How To Set Acurite Indoor Outdoor Thermometer

ACURITE Wireless Indoor/Outdoor Thermometer Instructions

Bombardment Installation
Batteries not incuded
Insert 2 fresh alkaline "AAA" batteries into the chief unit first, then the remote unit next. Practice not mix old and new batteries. Do not mix alkaline metal, standard (carbonzinc), or rechargeable (nickelcadmium) batteries.
Slide off the bombardment compartment comprehend on the back of each unit. Be sure to insert the batteries in the correct manner co-ordinate to the polarity symbols indicated in the battery compartment. Subsequently the batteries are installed in the principal unit, "IN" will brandish the main unit temperature. The "OUT" temperature will display "" due to the remote unit of measurement not existence powered on at this point.
Once batteries are installed, the remote unit will transmit the wireless bespeak to the main unit about once every minute. If the temperature does not brandish under the "OUT" on the principal unit after a few minutes, refer to the troubleshooting section of this manual.

Placement:
The main unit may be wall mounted using the builtin hanger, or information technology can be placed on a desk or table using the foldout stand. The remote sensor tin be wallmounted.
The remote unit is weather condition resistant. Proceed out of straight sunlight and direct weather elements to extend the life of the unit. Also, when selecting a location for the base unit of measurement, make sure information technology is within 100 feet of the wireless remote sensor. The range may be affected by electronic interference from devices such as televisions and computers. For the best results, keep both units at to the lowest degree 10 feet abroad from any electrical equipment or devices that may crusade electronic interference.

Troubleshooting:
If the primary unit displays "" in the "OUT" display expanse for more than a few minutes:

• The batteries may exist low in the wireless remote sensor unit.
• The wireless remote sensor unit may be out of range.
• Electronic devices or equipment may be causing interference relocate both units.
• Both units may need to be reset to reestablish wireless communications.

If this problem persists, remove and replace the batteries on both units and place both units in close proximity to each other for awhile. This may assistance reestablish communications and avoid whatsoever electronic interference in the area.

Specifications:

• Temperature measurement range:
  • MAIN Unit: 32ºF 122ºF
  • WIRELESS REMOTE: 0ºF 130ºF

Battery Compartment Access (dorsum)

Bombardment Prophylactic:
Follow the polarity(+/-) diagram in the bombardment compartment. Promptly remove dead batteries from the device. Dispose of used batteries properly. Merely batteries of the same or equivalent type equally recommended are to be used. Exercise Not incinerate used batteries. Exercise Non dispose of batteries in fire, as batteries may explode or leak. DO Not mix old and new batteries or types of batteries (alkaline/standard).DO NOT use rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.

This device complies with Part 15 of the FCC Rules. Operation is bailiwick to the following ii weather:

1. this device may not crusade harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
   Alarm: Changes or modifications to this unit of measurement not expressly approved by the party responsible for compliance could void the user'southward authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Grade B digital device, pursuant to Part xv of the FCC Rules. These limits are designed to provide reasonable protection confronting harmful interference in a residential installation. This equipment generates, uses and tin radiate radio frequency energy and, if non installed and used in accord with the instructions, may crusade harmful interference to radio communications.
   All the same, at that place is no guarantee that interference will not occur in a detail installation. If this equipment does cause harmful interference to radio or boob tube reception, which can be determined by turning the equipment off and on, the user is encouraged to attempt to correct the interference by 1 or more of the following measures:
   • Reorient or relocate the receiving antenna.
   • Increment the separation between the equipment and receiver.
   • Connect the equipment into an outlet on a circuit dissimilar from that to which the receiver is connected.
   • Consult the dealer or an experienced radio/Television set technician for help.

Do not return product to retail store. For Technical Aid and production render information,
please call Chaney Musical instrument Co. direct at:
877-221-1252

Limited WARRANTY – INTERNATIONAL

Conswner may take more remedies at law than follows. Chaney Musical instrument Company warrants to the possessor, this production to exist free from defect in material and workmanship

for one year from date of purchase. CHANEY INSTRUM:ENT SHALL Not Exist LIABLE FOR Whatsoever INCIDENTAL, INDIRECT OR CONSEQUENTIAL Amercement,

WHETHER ARISING IN CONTRACT OR TORT. Chaney Musical instrument's obligation (at its choice) is express to repair or replace this product. For in-warranty repair, send

clock, accompanied past Guarantee, bearing Dealer's name and date of purchase, with $5.00 to cover handling and postage, to:

www.chaneyinstrument.com
Tel: 877-221-1252 Made in China
Chaney Instrument Company
965 Wells Street Lake Geneva, Wisconsin 53147

Documents / Resources

References

• AcuRite Atmospheric condition Monitoring | #1 Weather Station Brand in North America

Source: https://manuals.plus/acurite/wireless-indooroutdoor-thermometer-manual

Share this post